Can a Scored or Worn Brake Disc Be Machined on 2001 Dodge Durango?

Should the disc be scored or worn out, it can be machined on a lathe that holds two cutters and turns both sides of the disc at the same time. Always make certain that the disc mounting surface is clean prior to using the lathe, because equipment limited to machining one side may create a tapered disc. Truing the disc to the vehicle's hub/bearing can be most effectively done with a hub mounted on-vehicle lathe. Any brake disc that is too thin before or after machining has to be replaced.

OEM 2001 Dodge Durango Brake Disc

Disc Rotor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Brake Disc found

View related parts
2001 Dodge Durango Rotor, Front Part Number: 52009208AD
Product Specifications
- Other Name: Rotor - Brake; Disc Brake Rotor, Front; Disc Brake Hardware Kit; Disc Brake Rotor; Brake Rotor
- Position: Front
- Replaces: 52009208, 52009208AE
- Item Weight: 17.40 Pounds
- Item Dimensions: 11.8 x 11.4 x 2.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 52009208AD
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2001 Dodge Durango Submodels:
- Base, R/T, SLT, SLT Plus, Sport | 3.9L V6, 4.7L V8, 5.2L V8, 5.9L V8, 6 Cyl 3.9 L GAS, 8 Cyl 4.7 L GAS, 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS

2001 Dodge Durango Brake Disc Parts and Q&A

Q: Can a Scored or Worn Brake Disc Be Machined on 2001 Dodge Durango?
A: Should the disc be scored or worn out, it can be machined on a lathe that holds two cutters and turns both sides of the disc at the same time. Always make certain that the disc mounting surface is clean prior to using the lathe, because equipment limited to machining one side may create a tapered disc. Truing the disc to the vehicle's hub/bearing can be most effectively done with a hub mounted on-vehicle lathe. Any brake disc that is too thin before or after machining has to be replaced.