OEM 2001 Jeep Wrangler Washer Reservoir

2001 Jeep Wrangler Washer Reservoir Parts and Q&A

• Q: How to Maintain a Washer Reservoir on 2001 Jeep Wrangler?

  A: You should begin by isolating the windshield washer reservoir from the battery by taking out the negative cable. Separate the reservoir from the front wheel house by unscrewing its three screws and then pick up the reservoir to see the washer pump or motor(s). You should take off the supply hose(s) from the motor unit(s) and dump the washer fluid into a clean container that can be used again. Remove the wires from the front (and rear, if necessary) washer pump/motor connectors plugged into the connectors in the motor and the body. Take the washer reservoir out of the engine compartment. For set up, secure the washer reservoir in its position in the engine compartment, plug in the rear body wire harness connector to the rear washer pump/motor if it can be done and link the headlamp and dash wire harness to the front washer pump/motor. Slide the washer supply hose(s) adjusters into the barbed nipple(s) on the washer pump unit(s). Afterward, set the washer reservoir onto the upright fender wheel house on the left side of the car. Attach the washer reservoir to the left front fender wheel house securely and tighten the three screws to 4 Nm (35 in. lbs.), put in fresh clean washer fluid and complete by plugging back in the battery negative cable.