How to Maintain a Washer Reservoir on 2000 Jeep Wrangler?

Make certain to disconnect and isolate the battery negative cable before adding fluid to the reservoir. Remove three screws from the washer reservoir and lift the reservoir enough to reach the washer pump(s). Release the washer supply hoses from the washer pumps and empty the fluid into a clean container you can reuse. Take out the wire connector(s) from the washer pump(s) and pull the washer reservoir away from the car. For installation, simply undo what you did when installing the original piece and set the reservoir mounting screws to 4 Nm (35 in. lbs.).

OEM 2000 Jeep Wrangler Washer Reservoir

Windshield Washer Reservoir

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Washer Reservoir found

View related parts
2000 Jeep Wrangler Washer Reservoir Part Number: 4874393
Product Specifications
- Other Name: Reservoir - Washer; Washer Fluid Reservoir; Windshield Washer Reservoir; Reservoir Washer
- Item Weight: 1.30 Pounds
- Item Dimensions: 10.2 x 8.1 x 6.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4874393
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2000 Jeep Wrangler Submodels:
- SE, Sahara, Sport, X | 4 Cyl 2.5 L GAS, 6 Cyl 4.0 L GAS

2000 Jeep Wrangler Washer Reservoir Parts and Q&A

Q: How to Maintain a Washer Reservoir on 2000 Jeep Wrangler?
A: Make certain to disconnect and isolate the battery negative cable before adding fluid to the reservoir. Remove three screws from the washer reservoir and lift the reservoir enough to reach the washer pump(s). Release the washer supply hoses from the washer pumps and empty the fluid into a clean container you can reuse. Take out the wire connector(s) from the washer pump(s) and pull the washer reservoir away from the car. For installation, simply undo what you did when installing the original piece and set the reservoir mounting screws to 4 Nm (35 in. lbs.).