How to Replace a Washer Pump on 2002 Jeep Grand Cherokee?

Question

Accepted Answer

Before starting, disconnect the battery cable and then support the vehicle so it is raised. Get rid of the fender wheel house liner on the left front fender and separate the left headlamp and dash wire harness from the motor connector receptacle. Uncouple the washer hose from the barbed outlet nipple where it meets the front washer pump/motor, so the fluid can drain into a container you can use again. With a trim stick or some other similar flat bladed accessory, carefully remove the barbed inlet nipple from the rubber grommet hole in the reservoir. Tear out and thoroughly get rid of the rubber grommet seal from the hole in which the washer pump is mounted. Before installing, fit a new rubber grommet seal into the place where the washer pump mounts. Insert the nipple from the wash pump into the rubber grommet seal and press evenly until it is snugly logged into the seal. Couple the washer hose back to the washer pump's barbed outlet nipple and secure the left headlamp and dash wire harness connector to the appropriate motor mount receptacle. Replace the windshield wiper liner in the left front fender wheel house, reinstall the vehicle and battery and top up the washer reservoir with the original washer fluid.

OEM 2002 Jeep Grand Cherokee Washer Pump

2 Washer Pumps found

2002 Jeep Grand Cherokee Washer Pump Part Number: 5103452AA

2002 Jeep Grand Cherokee Washer Pump Part Number: 5103453AA

2002 Jeep Grand Cherokee Washer Pump Parts and Q&A

Related 2002 Jeep Grand Cherokee Parts

Alternate Year Models