OEM 2005 Chrysler PT Cruiser Mirror Switch

2005 Chrysler PT Cruiser Mirror Switch Parts and Q&A

• Q: How to Maintain the Mirror Switch for Left-Hand Drive on 2005 Chrysler PT Cruiser?

  A: To replace the power mirror switch for the left-hand drive model, first remove the negative terminal from the battery. Lift the top part of the lower left bezel, move it down to the dash floor and quickly take it off the panel. After that, take out the two screws at the position of the left instrument panel end cover, gently pull the cover far enough to release it by unsnapping it and lift it out from beneath the left A-pillar and upper trim without taking them off. Separate the power mirror switch wiring connector from the system and also remove the end cover from the vehicle. On the workstation, carefully break open the mirror switch's four tabs and push it all the way through the cover. Set the mirror switch into the opening of the cover and hold it until it is secure and then fit the power mirror switch's wiring connector in its place. Set the left cover in position, rubber-side down, underneath the A-pillar trim and put it in place. Secure the left instrument panel end cover by putting the two screws in place and then make sure the left lower instrument panel bezel is in the same position and hinge orientation before snapping its hinge into the dash. After that, roll the bezel over the hands and secure it and attach the other end of the battery cable.