How to Service the Oil Pressure Switch on 2005 Chrysler PT Cruiser?

To maintain the oil pressure switch, lift the vehicle, place an oil collector under the right spot and then connect the engine ground. Unplug the electricity from the pressurized switch and pull the switch out. To set up the switch, install it and then renew the link on the electrical connector. Lower the car, begin the engine and let it idle for at least 2 minutes. Once you're finished, shut off the engine and verify and adjust if necessary the level of engine oil.

OEM 2005 Chrysler PT Cruiser Oil Pressure Switch

Oil Pressure Sender Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Oil Pressure Switch found

View related parts
2005 Chrysler PT Cruiser Switch - Oil Pressure Part Number: 5149098AB
$40.91 MSRP: $55.60
You Save: $14.69 (27%)
ADD TO CART
Product Specifications
- Other Name: SWITCH-OIL PRESSURE
- SKU: 5149098AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following 2005 Chrysler PT Cruiser Submodels:
- Base, Dream, Dream Cruiser, GT, LX, Limited, Street Cruiser, Touring | 2.4L L4, 4 Cyl 2.4 L GAS

2005 Chrysler PT Cruiser Oil Pressure Switch Parts and Q&A

Q: How to Service the Oil Pressure Switch on 2005 Chrysler PT Cruiser?
A: To maintain the oil pressure switch, lift the vehicle, place an oil collector under the right spot and then connect the engine ground. Unplug the electricity from the pressurized switch and pull the switch out. To set up the switch, install it and then renew the link on the electrical connector. Lower the car, begin the engine and let it idle for at least 2 minutes. Once you're finished, shut off the engine and verify and adjust if necessary the level of engine oil.