How to Locate, Remove, and Reinstall a Fuel Pump Relay on 2006 Dodge Dakota?

It can be found in the Power Distribution Center (PDC) and its label points to its exact place. Take off the PDC cover, then pull the relay out from the PDC to replace it. Check the terminals on the relay as well as on the PDC connector for signs of damage or corrosion; make any repairs and then put the relay back in place. Make sure the height of the pin is the same on all terminals and if there are any damaged parts, fix them before adding the PDC connector. First, place the relay into the PDC and put the cover back onto the PDC to finish installation.

OEM 2006 Dodge Dakota Fuel Pump Relay

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Fuel Pump Relay found

View related parts
2006 Dodge Dakota Fuel Pump Relay, Rear Part Number: 4727370AA
$26.96 MSRP: $39.90
You Save: $12.94 (33%)
ADD TO CART
Product Specifications
- Other Name: Relay - Mini; PCM Relay; Fan Relay; Accessory Relay(F/R); A/C Clutch; Starter; Fog Light; Fan Relay; Blower Motor Relay; Oxygen Sensor Relay; Mini 5 Terminal Square Relay.
- Position: Rear
- Replaces: 56006707, 56006709, 4848879AB, 4638094, 68369406AA, 68223712AA
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.3 x 1.4 x 1.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4727370AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2006 Dodge Dakota Submodels:
- Base, Big Horn, LE, Laramie, Lone Star, R/T, S, SLT, SLT Plus, ST, SXT, Sport, Sport Plus, TRX, TRX4, WS | 4 Cyl 2.5 L GAS, 6 Cyl 3.7 L GAS, 6 Cyl 3.9 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.2 L CNG, 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS

2006 Dodge Dakota Fuel Pump Relay Parts and Q&A

Q: How to Locate, Remove, and Reinstall a Fuel Pump Relay on 2006 Dodge Dakota?
A: It can be found in the Power Distribution Center (PDC) and its label points to its exact place. Take off the PDC cover, then pull the relay out from the PDC to replace it. Check the terminals on the relay as well as on the PDC connector for signs of damage or corrosion; make any repairs and then put the relay back in place. Make sure the height of the pin is the same on all terminals and if there are any damaged parts, fix them before adding the PDC connector. First, place the relay into the PDC and put the cover back onto the PDC to finish installation.