How to Service an Oil Pressure Switch on 2006 Dodge Dakota?

Clean the area near the battery and disconnect the sender cable. Unscrew the front splash shield, loosen the four bolts of the pressure sender connector (4) and take out the oil pressure sender (2). Begin with attaching the oil pressure sender and then add the oil pressure sender wire to the harness. Install the front splash shield again, bring the car down and join the negative battery cable last.

OEM 2006 Dodge Dakota Oil Pressure Switch

Oil Pressure Sender Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Oil Pressure Switch found

View related parts
2006 Dodge Dakota Oil Pressure Sending Unit Part Number: 4868672AA
Product Specifications
- Other Name: Switch - Oil Pressure; Engine Oil Pressure Switch; Oil Pressure Light Switch; Oil Pressure Switch; Switch Oil Pressure
- Item Weight: 0.50 Pounds
- Item Dimensions: 2.9 x 1.3 x 1.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4868672AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2006 Dodge Dakota Submodels:
- Base, Laramie, R/T, SLT, SLT Plus, ST, SXT, Sport, Sport Plus | 6 Cyl 3.7 L GAS, 6 Cyl 3.9 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.9 L GAS

2006 Dodge Dakota Oil Pressure Switch Parts and Q&A

Q: How to Service an Oil Pressure Switch on 2006 Dodge Dakota?
A: Clean the area near the battery and disconnect the sender cable. Unscrew the front splash shield, loosen the four bolts of the pressure sender connector (4) and take out the oil pressure sender (2). Begin with attaching the oil pressure sender and then add the oil pressure sender wire to the harness. Install the front splash shield again, bring the car down and join the negative battery cable last.