JeepParts
My Garage
My Account
Cart
OEM 2007 Dodge Durango Heater Core
HVAC Heater Core- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Heater Cores found
2007 Dodge Durango Heater Core, Front Part Number: 5166114AB
$218.99 MSRP: $330.00You Save: $111.01 (34%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Heater; HVAC Heater Core, Front; Core Heater Includes: Tubes, O - Rings, Seals, Clamps; Core Heater With Tubes And Seal; HVAC Heater Core
- Position: Front
- Replaces: 5166114AA
- Item Weight: 2.90 Pounds
- Item Dimensions: 22.7 x 11.0 x 10.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5166114AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
2007 Dodge Durango Heater Core, Rear Part Number: 5134383AA
Product Specifications- Other Name: Core - Heater; HVAC Heater Core, Rear; Core Heater Includes: Plate, Screw; Core Heater; HVAC Heater Core
- Position: Rear
- Item Weight: 3.20 Pounds
- Item Dimensions: 16.6 x 13.3 x 12.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5134383AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
2007 Dodge Durango Heater Core Parts and Q&A
- Q: How to Install a Heater Core in the Rear on 2007 Dodge Durango?A: Before you install the rear heater core, check that the heater core tubes are still intact and not touched, moved or disconnected to always avoid coolant leaks and risks. As the first step, attach the rear heater core (4) inside the rear HVAC housing (3) so that the insulator is seated correctly. After that, put on the rear heater core retaining bracket (2) and use screw (1) to secure it to the rear HVAC housing, turning until it reaches a tightness of 2 Nm (17 in. lbs.). Next, fit the outer half of the rear heater core and evaporator extension line flange (3) and tighten screws (2) which should all be tightened to 2 Nm (17 in. lbs.). Place the foam seal (1) against the rear heater core and evaporator extension line flange, then set in the rear blend door actuator and the housing for the rear climate system. Hook up the negative cable to the battery and only after a new rear heater core has been installed, flush the radiator and refill it with coolant, too. After that, evacuate everything and charge the refrigerant.
Related 2007 Dodge Durango Parts
2007 Dodge Durango Blower Motor
2007 Dodge Durango Blend Door Actuator
2007 Dodge Durango Blower Motor Resistor
2007 Dodge Durango A/C Accumulator
2007 Dodge Durango A/C Clutch
2007 Dodge Durango A/C Compressor
2007 Dodge Durango A/C Expansion Valve
2007 Dodge Durango A/C Hose
2007 Dodge Durango A/C Service Cap
2007 Dodge Durango A/C Switch
2007 Dodge Durango Blower Control Switches
2007 Dodge Durango HVAC Pressure Switch