OEM 2008 Chrysler Crossfire Brake Booster

2008 Chrysler Crossfire Brake Booster Parts and Q&A

• Q: How to Install a Brake Booster on 2008 Chrysler Crossfire?

  A: Reverse mounting for LHD vehicles means you should begin with a new gasket (3) at the booster before aligning it (1) in place on the dash panel. Add some Mopar(R) multi-mileage grease to the pedal pin and tighten the booster retaining nuts (2) to 39 Nm (29 ft. lbs.) after installation. After that, secure the brake rod pin (2) and the retaining clip (4). Examine the grommet (2) holding the check valve in the booster (3) and change it if it is damaged, then hook up the vacuum hose (1) to the booster check valve. Fit the master cylinder over the new gasket and screw in the nuts, checking every step to not damage the booster or master cylinder. The last stage is to fully fill the brake system and bleed it out using the pressure or manual method.