Other Name: Handle - Exterior Door; Exterior Door Handle, Rear Left Outer; Handle Exterior Door; Exterior Door Handle
Position: Rear Outer Driver Side
Replaces: TY25AXRAC, TY25AXRAB
Item Weight: 1.00 Pounds
Condition: New
Fitment Type: Direct Replacement
SKU: TY25AXRAD
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2008 Chrysler Pacifica Submodels:
Base, LX, Limited, Touring | 6 Cyl 3.5 L GAS, 6 Cyl 3.8 L GAS, 6 Cyl 4.0 L GAS
| Page 1 of 4 |Next >
1-20 of 70 Results
2008 Chrysler Pacifica Door Handle Parts and Q&A
Q: How to Install a Door Handle on the Rear Exterior on 2008 Chrysler Pacifica?
A: Start by fixing the outside door handle assembly inside the door panel. Set the outside door handle's screws to 4 Nm (37 in. lbs.) using a torque wrench. Afterwards, place the pivot leg of the handle in the front access hole and allow the rear of the handle to hit the outer panel while pushing on the front end. Put in the screw that attaches the cover over the outside handle, connect the clip to the outside handle, then the second clip to the door lock and finally the last clip on the door latch. Make sure the knob outside is moving freely to close the door and if you have to, install the watershield to gain access to the door handle. Then, add the door trim panel and use the door handle to be sure it works right, making any necessary fixes to the outside handle.