OEM 2008 Chrysler Pacifica Washer Reservoir

2008 Chrysler Pacifica Washer Reservoir Parts and Q&A

• Q: How to Install a Washer Reservoir on 2008 Chrysler Pacifica?

  A: Drain the existing fluid into the new reservoir 5 before you install it. Make sure to put a new grommet on the sensor before transferring it and do the same when moving the pumps. After that, slide reservoir 5 onto the pipeoster and attach all three of the reservoir bolts that hold it in place. Link the hoses and cables to reservoir 5, join the two lower facias to the grille clips and attach the top bolts at the ends. Following this, screw in the lower fascia push pins and add the screws at the splash shield by the left wheel opening. Remove your car from the hoist, attach the battery negative cable, check and top off the washer fluid level and close the hood.