OEM 2008 Dodge Caliber Washer Reservoir

2008 Dodge Caliber Washer Reservoir Parts and Q&A

• Q: How to Install a Washer Reservoir in the Engine Compartment on 2008 Dodge Caliber?

  A: Place the washer reservoir in the correct corner of the engine bay so the post under the reservoir fits into the hole found on the horizontal section of the front right wheel house. Mount the reservoir filler neck to the bracket on the sec ondary panel outside your car using the included screw. Link the washer hoses at the front and rear to the pump's reservoir hoses to prevent any problems with the washer function. Link the front and rear washer hoses to the reservoir washer hoses at the top of the right strut tower and attach the headlamp and dashwire connector to the washer pump/motor unit. On gasoline engines, set the coolant reserve container close to the washer reservoir on the inboard side and reattach all the containers fasteners. Add the washer fluid from the drain, replace the battery negative cable and close the lid.