OEM 2008 Dodge Viper Oil Filter

2008 Dodge Viper Oil Filter Parts and Q&A

• Q: How to Replace an Oil Filter on 2008 Dodge Viper?

  A: Before changing the engine oil and filter, run the engine at the regular operating temperature, park on level ground and then turn off the motor. Remove the oil fill cap from the engine and then lift the vehicle on a hoist. Position a pan directly below the drain hole in the oil pan, open the plug and let the oil out, checking the threaded hole for damage all the time; if it needs to be replaced, do so. After attaching the drain plug at the crankcase again, pull out the old oil filter and insert a new one. Lower your vehicle and put the correct kind of oil into the crankcase. After that, close the oil fill cap, check for leaks by starting the engine and recheck and adjust the oil as necessary. All cars from DaimlerChrysler Corporation use an advanced full-flow oil filter that must be changed each time the oil is serviced and it is encouraged to select a Mopar(R) or similar oil filter. Be careful when disposing of used engine oil to prevent harming the environment.