OEM 2009 Jeep Wrangler Cruise Control Switch

2009 Jeep Wrangler Cruise Control Switch Parts and Q&A

• Q: How to Install the Cruise Control Switch and Complete the Airbag System Test on 2009 Jeep Wrangler?

  A: You should connect the electrical connector to the switch when installing the speed control switch. Every model requires a screw for hole 1 and for some model lines, there are others that need two screws, while others use one screw plus a locating pin for hole 2. Attach the switch and its mounting screws, making sure the rubber seal goes around the switch first and that the screws are driven in to 1.6 Nm (15 in. lbs.) tightness. After that, screw in the horn switch and three supports for mounting, followed by joining the electrical connector to the Clock Spring. Set up the air bag, remembering not to attach the negative cable of the battery until the air bag system test has run. After the test, complete the air bag System Test and put the battery back, close the hood and examine the vehicle and the system.