How to Service and Repair an HVAC Pressure Switch on 2010 Chrysler Town & Country?

Anytime you remove the HVAC pressure switch, replace its O-ring first so no refrigerant leaks can occur while the unit is apart. Before installing a new rubber O-ring seal, coat it lightly with special refrigerant oil and make sure it is only the O-ring made out of R-134a material and that you are using the correct oil as well. After that, place the HVAC pressure switch (2) on the fitting and make sure it is tightened to 5.6 Nm (50 in. lbs.). Connect the fitting from the harness (1) to the HVAC pressure switch and then mount the air cleaner assembly and its ducting again. After that, reattach the negative battery cable.

OEM 2010 Chrysler Town & Country HVAC Pressure Switch

Air Pressure Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 HVAC Pressure Switch found

View related parts
2010 Chrysler Town & Country Pressure Switch Part Number: 5174039AB
$118.97 MSRP: $175.00
You Save: $56.03 (33%)
Product Specifications
- Other Name: Valve - A/C Pressure Transducer; Refrigerant, HVAC, Compressor, Trinary Switches; Pressure Transducer; Includes O-Ring and Item #4; Discharge Line Valve.
- Replaces: 5175684AA, 5189363AA, 5096084AA, 5174039AA
- Item Weight: 0.40 Pounds
- Item Dimensions: 1.1 x 1.2 x 2.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5174039AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2010 Chrysler Town & Country Submodels:
- Base, EL, EX, LX, LXi, Limited, SX, Touring, Touring L, Touring Plus, Walter P. Chrysler Signature Series | 6 Cyl 3.3 L FLEX, 6 Cyl 3.3 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS, 6 Cyl 3.8 L GAS, 6 Cyl 4.0 L GAS

2010 Chrysler Town & Country HVAC Pressure Switch Parts and Q&A

Q: How to Service and Repair an HVAC Pressure Switch on 2010 Chrysler Town & Country?
A: Anytime you remove the HVAC pressure switch, replace its O-ring first so no refrigerant leaks can occur while the unit is apart. Before installing a new rubber O-ring seal, coat it lightly with special refrigerant oil and make sure it is only the O-ring made out of R-134a material and that you are using the correct oil as well. After that, place the HVAC pressure switch (2) on the fitting and make sure it is tightened to 5.6 Nm (50 in. lbs.). Connect the fitting from the harness (1) to the HVAC pressure switch and then mount the air cleaner assembly and its ducting again. After that, reattach the negative battery cable.