To service the third row outboard seat belt, examine the seat belt, buckle, all its mounting hardware, retractor, tether strap and anchors, changing any worn belts, correcting twists in the belts, tightening any lose fasteners and changing any broken buckles, retractors, latch plates or anchor plates with parts ordered from the DaimlerChrysler Mopar(R) Parts Catalog. Lower the
Seat Cushion on the third row and hold the seat back upright so you can easily reach the lower seat belt anchor on the quarter inner panel. Unscrew the bolt holding the lower anchor to the inner dent-protection panel on the quarter side, then take away the D-pillar panel covering the upper back inner panel. Go through the hole in the panel on the upper D-pillar and secure the seat belt and lower anchor. Unscrew the fixing screw in the upper D-pillar to separate the turning loop. After that, get the quarter trim panel away from the lower D-pillar and unscrew the retractor bracket from it. Thereafter, remove the entire third row seat belt and retractor by grabbing them at the D-pillar.