OEM Chrysler Pacifica Parking Brake Cable

Chrysler Pacifica Parking Brake Cable Parts and Q&A

• Front Cable
  4683912AD
  Q: How to Remove and Repair a Parking Brake Cable on Chrysler Pacifica?

  A:

  Begin by holding down the automatic adjuster button in the parking brake lever, handbrake and then raise and support the car before continuing. Sometimes, releasing tension in the Parking Brake Shoe will allow you to take the cable out even if the button is stuck. Push the left back cable button 11 inward as far as it will go and take it out of the equalizer 10. With the end of the front cable held firmly by pliers at its button, slide the right rear cable button toward the center and remove it from the cable connector. Take out the rear hub and bearing, then remove bolt 1 on the parking brake cable from the knuckle. Then, take the parking brake shoes off the support and simultaneously remove actuator 1 from the support end of cable 2. Get the cable out of the support plate and knuckle and use a 13 mm 12-point wrench to compress the cable retainer on the end of the cable's housing fastened to the crossmember.
• Rear Cable
  4683858AD
  Q: How to Install the Right Rear Parking Brake Cable on Chrysler Pacifica?

  A:

  Take the leading end of the cable and ease it into the hole in the flange of the crossmember, then push the cable retainer into the hole until you feel its fingers lock into place. Then, insert the other cable side into the knuckle and shoe support so that "UP" is clearly visible when the actuator is installed. First, fit the shoe actuator to the end of the parking brake cable near the Parking Brake Shoes and then connect the shoes to the support. Connect the parking brake cable to the knuckle at the end of the brake rod, then tighten bolt 2 to 28 Nm (21 ft. lbs.). To access everything needed, ensure you have the hub, bearing and wheel speed sensor along the wheel, plus all required components. With your pliers gripping the front cable button, put the right rear button 4 into the cable connector and let both cables go, putting pressure on the button to seat it. Do the same at the left rear by using the equalizer and pressing the button down with your hand if needed. Lower the car, then adjust the parking brake shoes after switching the automatic adjuster off in the parking brake lever.