OEM Dodge Nitro Parking Assist Sensor

Dodge Nitro Parking Assist Sensor Parts and Q&A

• Reverse Sensor, Black
  1AF63S3XAA
  Q:

  How to Install Parking Assist Sensors on Dodge Nitro?

  A:

  First, set the O-ring spacer at the sensor's circumference, so that the part facing the rear fascia is narrow and meets the outer part of the sensor while the wide side sits against the sensor housing. Then, connect and hold the sensor firmly in the sensor bracket at the back of the rear bumper fascia until the locks from the bracket are over both top and bottom latch tabs on the sensor, with the sensor membrane level with the external side of the fascia. Properly placing and centering each sensor membrane within the openings of the rear fascia and leaving the O-ring spacers un-pinched, are essential, since wrong centering or shredded O-rings may hamper the parking assist distance sensors. Then, join the wire harness connector once again with the one on the back of the fascia. Once finished, install the rear wheel flare and the attached bumper fascia on the same side of the car and attach the negative Battery Cable.
• Reverse Sensor, Black, Rear
  1AF63TZZAA
  Q:

  How to Maintain Parking Assist Sensors on Dodge Nitro?

  A:

  Parking assist distance sensors should be serviced by first unconnecting the battery negative cable. Undo the wheel flare in the back and, on the side of the car with service required, loosen the bumper fascia. From where the fascias connect to the liftgate, remove the parking assist distance sensor connector from the wire harness. Unlock the sensor bracket hook features by pulling the top and bottom hooks away. After that, take off the O-ring spacer from the bottom of the sensor membrane. If parts need to be serviced, the parking assist distance sensor and sensor spacers can be reached separately, but the sensor brackets are mounted to the rear bumper by adhesive.