Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
Fits the following Vehicles:
1999 Dodge Ram 1500 Van | Base | 6 Cyl 3.9 L GAS, 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS
Dodge Ram 1500 Van Steering Column Cover
Choose OEM Steering Column Cover that meet Dodge factory standards. Dodge designs and tests every component for precision and durability. Each Steering Column Cover follows strict manufacturing steps to lock in quality and fit. If your Dodge Ram 1500 Van matters to you, OEM parts make the smart choice. You'll get the exact look, feel, and performance you expect. Shop genuine Ram 1500 Van parts at the highly competitive prices online. Enjoy a manufacturer's warranty, a hassle-free return policy, and rapid delivery. No more guesswork with off brands. Get genuine parts with exact fit and true factory performance. Shop with confidence today at JeepPartsDeal.com.
Dodge Ram 1500 Van Steering Column Cover Parts and Q&A
Q: How to service the Steering Column Cover on Dodge Ram 1500 Van?
A:
Service the steering column cover by unplugging and disconnecting the air bag battery first, waiting two minutes to let the capacitor discharge and following the steps. If your car is equipped, adjust the tilt steering column all the way up. Take the end cap from the left end of the instrument panel and then remove the three screws that fasten the lower part of the steering column opening cover to the knee blocker and the two screws that hold the outboard end of the cover to the left instrument panel bracket. Slide the prying tool carefully between the steering column opening cover and the instrument panel just below the cluster bezel to release the snap clip holders. Get rid of the insurance certificate covering your instrument panel. Place the opening cover for the steering column over the instrument panel and fit the four snap clip retainers into their receptacles. Squeeze the camera cover hard along the snap clip areas until the clips are all hooked in place. Screw the two screws holding the left instrument panel cover to the outboard bracket counterclockwise until they are 2 N.m (20 in. lbs.) and then install and tighten the three lower screws to the knee blocker to the same tension. Reattach the end cap onto the left end of the instrument panel and link the battery negative cable back to the car.