How to Remove the Starter Motor from 3.7L, 4.7L, and 5.7L Gas Engines on Dodge Ram 2500?

For both 3.7L / 4.7L and 5.7L gas engines, start by removing the negative battery cable and supporting the vehicle before you work. For vehicles fitted with 4WD and matching transmissions, remove the bolts at the support bracket of the transmission and use a pry bar to wiggle the bracket and locate the lower starter bolt. If you have a manual transmission, loosen only one bolt and one nut; for an automatic, loosen two mounting bolts. Advance the starter motor towards the front of the car, confirming that the end of the starter pinion housing clears the housing, then support the motor and don't let it touch the wire harness. Reduce the nose to look down at the car; then, lower the starter motor enough to take out the nut and remove the eyelet on the solenoid battery terminal stud. Then, remove the battery positive cable wire harness connector from the solenoid terminal connector receptacle and pull out the starter motor.

How to Effectively Service and Repair a Starter Motor on Dodge Ram 2500?

Before handling the starter, isolate and remove the negative cables from the batteries and raise the vehicle to give yourself access. Lift the rubber boot off the solenoid battery terminal and then unscrew the nut holding the battery positive cable wire harness connector eyelet to the terminal stud. Take out the nut and the battery positive cable wire harness eyelets from the solenoid studs. When the starter motor seems supported, unscrew three screws holding it against the flywheel housing and carefully remove the starter motor from the engine, keeping in mind the proper position and orientation of any matching aluminum spacer. During installation, put the aluminum spacer towards the back of the starter, when available and then attach the starter motor to the engine while leaving the three bolts a little loose. Fix the eyelets onto the studs and bolt them on with the nuts using 13.6 Nm (120 in. lbs.) for the bigger nut and 6.2 Nm (55 in. lbs.) for the small nut. Very last, slide the boot onto the stud and put the vehicle back on the ground, then attach the battery cables to both.

OEM Dodge Ram 2500 Starter Motor

Starter Ignition

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

13 Starter motors found

View related parts
Dodge Ram 2500 Starter Part Number: 56029274AA
$215.71 MSRP: $319.00
You Save: $103.29 (33%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Motor Reman; Starters; Starter Engine
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2005-2008 Dodge Ram 2500 | Laramie, Power Wagon, SLT, ST, SXT, Sport, TRX4 | 8 Cyl 5.7 L GAS
View related parts
Dodge Ram 2500 Starter Part Number: 56044736AC
$285.96 MSRP: $419.00
You Save: $133.04 (32%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Engine
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2005-2010 Dodge Ram 2500 | Laramie, Power Wagon, SLT, ST, SXT, Sport, TRX, TRX4 | 8 Cyl 5.7 L GAS
View related parts
Dodge Ram 2500 Starter Part Number: 5086932AA
$944.14 MSRP: $1425.00
You Save: $480.86 (34%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Motor Reman; Starters; Starter Engine
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2003-2007 Dodge Ram 2500 | Laramie, SLT, ST, Sport, TRX4 | 6 Cyl 5.9 L DIESEL
View related parts
Dodge Ram 2500 Starter Part Number: R6027702AC
$188.42 MSRP: $275.00
You Save: $86.58 (32%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Engine
- Replaces: 56027702AB, 56027702AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1999-2003 Dodge Ram 2500 | Base | 5.9L V8, 8 Cyl 5.9 L GAS
View related parts
Dodge Ram 2500 Starter Part Number: 56027702AB
$188.42 MSRP: $275.00
You Save: $86.58 (32%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Starter Motor; Starter Engine
- Replaced by: R6027702AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1999 Dodge Ram 2500 | Base
View related parts
Dodge Ram 2500 Starter Part Number: R4741012
$540.76 MSRP: $650.00
You Save: $109.24 (17%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Starter Motor Reman; Starter Motor; Starters; Starter Engine
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1994-2002 Dodge Ram 2500 | Base | 6 Cyl 5.9 L DIESEL
View related parts
Dodge Ram 2500 Starter Engine Part Number: R8049020AA
$374.25 MSRP: $438.00
You Save: $63.75 (15%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Starter - Engine
- Replaced by: R8444855AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2007-2010 Dodge Ram 2500 | Laramie, SLT, ST, SXT, Sport, TRX, TRX4 | 6 Cyl 5.9 L DIESEL, 6 Cyl 6.7 L DIESEL
View related parts
Dodge Ram 2500 Starter Part Number: 56028715AD
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Engine
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2003-2004 Dodge Ram 2500 | Laramie, SLT, ST | 8 Cyl 5.7 L GAS
View related parts
Dodge Ram 2500 Starter Part Number: 56027703AD
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Engine
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2003 Dodge Ram 2500 | Laramie, SLT, ST | 10 Cyl 8.0 L GAS
View related parts
Dodge Ram 2500 Starter Part Number: 56028733AA
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Engine
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2003-2004 Dodge Ram 2500 | Laramie, SLT, ST | 8 Cyl 5.7 L GAS
View related parts
Dodge Ram 2500 Starter Part Number: R6027703AC
Product Specifications
- Other Name: Starter - Engine; Starter Motor; Starter Engine
- Replaces: 56027703AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1999-2002 Dodge Ram 2500 | Base | 10 Cyl 8.0 L GAS, 8.0L V10
View related parts
Dodge Ram 2500 Starter Part Number: 53005984AB
Product Specifications
- Other Name: Starter - Engine
- Replaces: 53005984, R3005984
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1994-1996 Dodge Ram 2500 | Base | 5.2L V8, 5.9L V8, 8 Cyl 5.2 L CNG, 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS, 8.0L V10
View related parts
Dodge Ram 2500 Starter Part Number: 5016522AA
Product Specifications
- Other Name: Starter Motor
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2002, 1994-1996 Dodge Ram 2500 | Base | 6 Cyl 5.9 L DIESEL

Dodge Ram 2500 Starter Motor

Choose OEM Starter Motor that meet Dodge factory standards. Dodge designs and tests every component for precision and durability. Each Starter Motor follows strict manufacturing steps to lock in quality and fit. If your Dodge Ram 2500 matters to you, OEM parts make the smart choice. You'll get the exact look, feel, and performance you expect. Shop genuine Ram 2500 parts at the highly competitive prices online. Enjoy a manufacturer's warranty, a hassle-free return policy, and rapid delivery. No more guesswork with off brands. Get genuine parts with exact fit and true factory performance. Shop with confidence today at JeepPartsDeal.com.

The Starter Motor Motor in Dodge Ram 2500 is a very vital component which is needed to turn the electrical energy stored in the battery into mechanical energy to start the cars engine. It consists of an externally fixed solenoid which is connected to the battery with the help of a switch and the starter motor. In the starter, either field coils or permanent magnets are provided which rotate an armature and create the required torque. The starter drive couples with the engine flywheel each time the ignition is switched on and an over running clutch releases it when the engine is running. In the past and up to the present, the Dodge Ram 2500 models have employed different types of starters, but the most widely used are the electric starters. One of the improvements is the gear reduction starters whereby a reduction gear is used to engage the drive. OE starters work for normal engines, but for high compression engines the increased load demands may call for additional special starters to avoid frequent failure.

Dodge Ram 2500 Starter Motor Parts and Q&A

Starter
56044736AC
Q: How to Remove the Starter Motor from 3.7L, 4.7L, and 5.7L Gas Engines on Dodge Ram 2500?
A:
For both 3.7L / 4.7L and 5.7L gas engines, start by removing the negative Battery Cable and supporting the vehicle before you work. For vehicles fitted with 4WD and matching transmissions, remove the bolts at the support bracket of the transmission and use a pry bar to wiggle the bracket and locate the lower starter bolt. If you have a manual transmission, loosen only one bolt and one nut; for an automatic, loosen two mounting bolts. Advance the starter motor towards the front of the car, confirming that the end of the starter pinion housing clears the housing, then support the motor and don't let it touch the wire harness. Reduce the nose to look down at the car; then, lower the starter motor enough to take out the nut and remove the eyelet on the solenoid battery terminal stud. Then, remove the battery positive cable wire harness connector from the solenoid terminal connector receptacle and pull out the starter motor.
Starter
R4741012
Q: How to Effectively Service and Repair a Starter Motor on Dodge Ram 2500?
A:
Before handling the starter, isolate and remove the negative cables from the batteries and raise the vehicle to give yourself access. Lift the rubber boot off the solenoid battery terminal and then unscrew the nut holding the battery positive cable wire harness connector eyelet to the terminal stud. Take out the nut and the battery positive cable wire harness eyelets from the solenoid studs. When the starter motor seems supported, unscrew three screws holding it against the flywheel housing and carefully remove the starter motor from the engine, keeping in mind the proper position and orientation of any matching aluminum spacer. During installation, put the aluminum spacer towards the back of the starter, when available and then attach the starter motor to the engine while leaving the three bolts a little loose. Fix the eyelets onto the studs and bolt them on with the nuts using 13.6 Nm (120 in. lbs.) for the bigger nut and 6.2 Nm (55 in. lbs.) for the small nut. Very last, slide the boot onto the stud and put the vehicle back on the ground, then attach the Battery Cables to both.