How to Locate, Remove, and Install a Knock Sensor on 2001 Dodge Neon?

On the cylinder block, the knock sensor is to the side of the starter motor. First, disconnect the knock sensor's electrical connector, then take out the sensor with a crow foot socket. Put the knock sensor in the same spot and tighten it using 10 Nm torque, because improperly fastened sensors may lead to incorrect use and spark control. After that, click the electrical connector back onto the knock sensor.

OEM 2001 Dodge Neon Knock Sensor

Engine Knock Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Knock Sensor found

View related parts
2001 Dodge Neon Knock Sensor Part Number: 4557667
Product Specifications
- Other Name: Sensor - Knock; Ignition Knock (Detonation) Sensor; Sensor, Knock, 3.3-3.8 Engine; Sensor, Knock; Sensor Knock
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4557667
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following 2001 Dodge Neon Submodels:
- ACR, Base, ES, High Line, R/T, SE, Sport | 4 Cyl 2.0 L GAS

2001 Dodge Neon Knock Sensor Parts and Q&A

Q: How to Locate, Remove, and Install a Knock Sensor on 2001 Dodge Neon?
A: On the cylinder block, the knock sensor is to the side of the starter motor. First, disconnect the knock sensor's electrical connector, then take out the sensor with a crow foot socket. Put the knock sensor in the same spot and tighten it using 10 Nm torque, because improperly fastened sensors may lead to incorrect use and spark control. After that, click the electrical connector back onto the knock sensor.