How to Locate, Remove, and Install a Knock Sensor on 2002 Dodge Neon?

You can find the knock sensor on the side of the cylinder block in front of the starter. To remove the knock sensor, disconnect the connector, then use a crow foot socket on the sensor. Install the knock sensor by threading it into its original place and tightening until you reach 10 Nm (7 ft. lbs.). Improper tightening can cause it to malfunction and lead to wrong spark control. Connect the knock sensor to the electrical connector at the end.

OEM 2002 Dodge Neon Knock Sensor

Engine Knock Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Knock Sensor found

View related parts
2002 Dodge Neon Knock Sensor Part Number: 4557667
Product Specifications
- Other Name: Sensor - Knock; Ignition Knock (Detonation) Sensor; Sensor, Knock, 3.3-3.8 Engine; Sensor, Knock; Sensor Knock
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4557667
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following 2002 Dodge Neon Submodels:
- ACR, Base, ES, High Line, R/T, SE, Sport | 4 Cyl 2.0 L GAS

2002 Dodge Neon Knock Sensor Parts and Q&A

Q: How to Locate, Remove, and Install a Knock Sensor on 2002 Dodge Neon?
A: You can find the knock sensor on the side of the cylinder block in front of the starter. To remove the knock sensor, disconnect the connector, then use a crow foot socket on the sensor. Install the knock sensor by threading it into its original place and tightening until you reach 10 Nm (7 ft. lbs.). Improper tightening can cause it to malfunction and lead to wrong spark control. Connect the knock sensor to the electrical connector at the end.