How to Service a Pitman Arm on 2001 Jeep Wrangler?

First loosen the cotter pin and take out the nut from the drag link next to the pitman arm and then pull the drag link ball stud off the pitman arm. Subsequently, unscrew and keep the nut and washer taken from the steering gear shaft, making notes of their places and pull out the pitman arm by reference with Puller C-4150A. Put the pitman arm on the steering gear shaft, lined up with the castle nut and secure the nut with the washer; tighten the nut to 251 Nm (185 ft. lbs.). Then, connect the drag link ball stud to the pitman arm and bolt it with a nut at 81 Nm (60 ft.-lbs.), plus a new cotter pin.

OEM 2001 Jeep Wrangler Pitman Arm

Steering Pitman Arm

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Pitman Arm found

View related parts
2001 Jeep Wrangler Pitman Arm Part Number: 52038337
$55.21 MSRP: $121.00
You Save: $65.79 (55%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Arm - Pitman; Steering Pitman Arm; Idler Arm; Arm Pitman
- Item Weight: 2.30 Pounds
- Item Dimensions: 1.7 x 10.6 x 12.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 52038337
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2001 Jeep Wrangler Submodels:
- 65th Anniversary Edition, Rubicon, SE, Sahara, Sport, Unlimited, Unlimited Rubicon, X | 4 Cyl 2.4 L GAS, 4 Cyl 2.5 L GAS, 6 Cyl 4.0 L GAS

2001 Jeep Wrangler Pitman Arm Parts and Q&A

Q: How to Service a Pitman Arm on 2001 Jeep Wrangler?
A: First loosen the cotter pin and take out the nut from the drag link next to the pitman arm and then pull the drag link ball stud off the pitman arm. Subsequently, unscrew and keep the nut and washer taken from the steering gear shaft, making notes of their places and pull out the pitman arm by reference with Puller C-4150A. Put the pitman arm on the steering gear shaft, lined up with the castle nut and secure the nut with the washer; tighten the nut to 251 Nm (185 ft. lbs.). Then, connect the drag link ball stud to the pitman arm and bolt it with a nut at 81 Nm (60 ft.-lbs.), plus a new cotter pin.