JeepParts
My Garage
My Account
Cart
OEM 2002 Dodge Durango Blower Motor
A/C Heater Blower Motor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
2 Blower Motors found
2002 Dodge Durango Blower Motor, Rear Part Number: 5019640AB
$118.88 MSRP: $197.00You Save: $78.12 (40%)Ships in 1-2 Business DaysProduct Specifications- Other Name: Motor - Blower With Wheel; HVAC Blower Motor, Rear; Motor Blower With Wheel
- Position: Rear
- Replaces: 5019640AA
- Item Weight: 3.70 Pounds
- Item Dimensions: 10.0 x 9.9 x 8.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5019640AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
2002 Dodge Durango Blower Motor, Front Part Number: 4885669AC
Product Specifications- Other Name: Motor - Blower With Wheel; HVAC Blower Motor, Front; Blower Assembly; Motor Blower With Wheel; HVAC Blower Motor
- Position: Front
- Item Weight: 4.20 Pounds
- Item Dimensions: 11.6 x 11.2 x 9.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4885669AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
2002 Dodge Durango Blower Motor Parts and Q&A
- Q: How to Service the Blower Motor with the Optional Rear Heater-A/C Unit on 2002 Dodge Durango?A: The only rear blower motor used on quality models with a rear heating and cooling unit is balanced at the factory and should be handled as a group with the wheel, housing and all mounting hardware. First remove the battery negative cable and isolate it, then open and take the inside trim panel away from the passenger compartment. First, pull out the motor connection, then take off the three screws that hold the blower motor in the heater A/C housing at the back. For step 4, place the rear blower motor and wheel onto the heater-A/C unit and begin securing it with three screws. Make sure the rear A/C unit's wire harness is sitting in the guide holes located on either end of the blower housing, then screw it into place with three mounting screws tightened to 3 Nm (27 inch-pounds). Last, connect the rear blower motor wire harness to the car and put the negative cable of the battery back.
Related 2002 Dodge Durango Parts
2002 Dodge Durango Blend Door Actuator
2002 Dodge Durango Heater Core
2002 Dodge Durango Blower Motor Resistor
2002 Dodge Durango Evaporator
2002 Dodge Durango A/C Accumulator
2002 Dodge Durango A/C Clutch
2002 Dodge Durango A/C Compressor
2002 Dodge Durango A/C Condenser
2002 Dodge Durango A/C Expansion Valve
2002 Dodge Durango A/C Hose
2002 Dodge Durango A/C System Valve Core
2002 Dodge Durango HVAC Pressure Switch