How is the MAP Sensor Installed and Serviced on the Intake Manifold on 2003 Dodge Neon?

Before you service the MAP sensor, disconnect its electrical connector and then remove the sensor mounting screws to pull the sensor out. Ensure the O-ring on the inlet manifold is not torn as you attach the new sensor, then tighten the mount screws to 4.5 Nm (40 in. lbs.) for any plastic intake manifold. After that, you can connect the electrical connector to the sensor.

OEM 2003 Dodge Neon MAP Sensor

Manifold Air Pressure Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 MAP Sensors found

View related parts
2003 Dodge Neon M.A.P. Sensor Part Number: 5033224AB
$56.38 MSRP: $81.15
You Save: $24.77 (31%)
Product Specifications
- Other Name: Sensor - Map; Manifold Absolute Pressure Sensor; Manifold Sensor; Pressure Sensor; MAP Sensor; Sensor Map
- Replaces: 5033224AA
- Item Weight: 0.50 Pounds
- Item Dimensions: 2.7 x 2.3 x 1.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5033224AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2003 Dodge Neon Submodels:
- SRT-4 | 2.4L L4, 4 Cyl 2.4 L GAS
View related parts
2003 Dodge Neon M.A.P. Sensor Part Number: 4896003AB
Product Specifications
- Other Name: Sensor - Map; Manifold Absolute Pressure Sensor; Manifold Sensor; MAP Sensor; Sensor Map; Pressure Sensor
- Replaces: 4896003AA, 4896002AD
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.8 x 2.6 x 3.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4896003AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2003 Dodge Neon Submodels:
- R/T, SE, SXT | 2.0L L4, 4 Cyl 2.0 L GAS

2003 Dodge Neon MAP Sensor Parts and Q&A

Q: How is the MAP Sensor Installed and Serviced on the Intake Manifold on 2003 Dodge Neon?
A: Before you service the MAP sensor, disconnect its electrical connector and then remove the sensor mounting screws to pull the sensor out. Ensure the O-ring on the inlet manifold is not torn as you attach the new sensor, then tighten the mount screws to 4.5 Nm (40 in. lbs.) for any plastic intake manifold. After that, you can connect the electrical connector to the sensor.