OEM 2006 Chrysler PT Cruiser Crankshaft Seal

2006 Chrysler PT Cruiser Crankshaft Seal Parts and Q&A

• Q: How to Service and Repair a Crankshaft Seal on 2006 Chrysler PT Cruiser?

  A: Begin by removing the transaxle and the flex plate before you work on the crankshaft main bearing seal. Place the blade of a 3/16 flat-headed screwdriver between the rear rim of the dust lip and the most protruding section of the case and gently work out the seal. Before you set the seal in place, inspect the crankshaft's edge for burrs or scratches and sand them out with 400 grit sandpaper to protect it. No lubrication is necessary when installing the seal. Slide Rear Crankshaft Seal Guide 6926-1 on the crankshaft and bear the seal over the groove, so the seal lip points into the crankcase. Place the Rear Crankshaft Seal Installer 6926-2 through the seal and use the Driver Handle C-4171 until you feel it hit the block, stopping before the seal goes in past flush to avoid leaks. When installation is complete, use Mopar Lock & Seal Adhesive on the bolt threads, then tighten them to 95 Nm (70 ft. lbs.); lastly, connect the transaxle.