OEM 2008 Chrysler PT Cruiser Washer Reservoir

2008 Chrysler PT Cruiser Washer Reservoir Parts and Q&A

• Q: How to Install a Washer Reservoir on 2008 Chrysler PT Cruiser?

  A: Start by pushing the pump inside the grommet and then secure it with a plastic strap snapped into the reservoir. Then, put the reservoir in the cowl area and attach both hoses so the one with the white stripe connects to the white side of the pump and the black hose to black side. Attach the pump wire connector and hold the reservoir in place by tightening the three supplied retaining screws to a torque of 8 Nm (70 in. lbs.). Fit the right side cowl cover onto its side, first positioning it so it overlaps the left side cover. You should then be able to install the four push retainers to hold the cover in place. Secure the cowl seal in the back engine compartment. Before fitting the wiper arms, first switch on the wipers to confirm the wipers are in PARK mode and line up the driver's and passenger's blades with the rulings by the glass. Set the arm on the pivot so it is just above centered, screw in the retaining nut to 21 Nm (190 in. lbs.) and then attach the wiper arm nut cap. Connect the red battery cable, shut the hood and check to see if everything is working.