Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
More Info
Fits the following 2008 Jeep Commander Submodels:
Limited, Overland, Sport | 3.7L V6, 4.7L V8, 5.7L V8, 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L GAS
| Page 1 of 2 |Next >
1-20 of 35 Results
2008 Jeep Commander Seat Belt Parts and Q&A
Q: How to Maintain the Third Row Seat Belt on 2008 Jeep Commander?
A: First, look over everything in the third row seat belt, change cut, torn or frayed pieces and fasten any loose connections. Take out the third row seat, then unscrew the anchor for the seat belt at the outboard rear corner of the third row seat support bracket. Then, take out the two screws from the seat back and use that motion to detach the seat belt webbing from the escutcheon it is attached to. Start by taking away the trim from the third row seat's back and top, then pull out the through bolt that keeps the retainer bracket in place with the front upper outboard corner of the seat back frame. Remove the retractor retainer bracket from the top edge of the retractor pocket and then loosen the screw holding the retractor in the back of the seat back. At the end, pull out the third row seat belt and retractor as a group through the upper outside pocket on the front of the seat back.