How to Locate, Remove, and Inspect a Fuel Pump Relay on 2008 Jeep Commander?

The PDC or Power Distribution Center, contains the fuel pump relay and its name can be easily found on the PDC cover. Start by removing the PDC cover and then take out the relay from the PDC. Examine the relays' terminals and the terminals on the PDC connector for any signs of damage or rust and either repair them or replace them before turning on the relay again. Make certain the height of each pin in the PDC connector is the same which allows you to repair or change them first before connecting the relay to the circuit.

OEM 2008 Jeep Commander Fuel Pump Relay

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Fuel Pump Relay found

View related parts
2008 Jeep Commander Fuel Pump Relay, Rear Part Number: 4727370AA
$26.96 MSRP: $39.90
You Save: $12.94 (33%)
ADD TO CART
Product Specifications
- Other Name: Relay - Mini; PCM Relay; Fan Relay; Accessory Relay(F/R); A/C Clutch; Starter; Fog Light; Fan Relay; Blower Motor Relay; Oxygen Sensor Relay; Mini 5 Terminal Square Relay.
- Position: Rear
- Replaces: 56006707, 56006709, 4848879AB, 4638094, 68369406AA, 68223712AA
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.3 x 1.4 x 1.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4727370AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2008 Jeep Commander Submodels:
- 65th Anniversary Edition, Base, Limited, Overland, Sport | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L GAS

2008 Jeep Commander Fuel Pump Relay Parts and Q&A

Q: How to Locate, Remove, and Inspect a Fuel Pump Relay on 2008 Jeep Commander?
A: The PDC or Power Distribution Center, contains the fuel pump relay and its name can be easily found on the PDC cover. Start by removing the PDC cover and then take out the relay from the PDC. Examine the relays' terminals and the terminals on the PDC connector for any signs of damage or rust and either repair them or replace them before turning on the relay again. Make certain the height of each pin in the PDC connector is the same which allows you to repair or change them first before connecting the relay to the circuit.