How to Service and Repair a Tie Rod End on 2009 Dodge Viper?

Before servicing or repairing the tie rod end, raise and support the vehicle. After that, take off the front wheel and tire assembly. Begin by loosening the jam nut (2) on the inside and once that's loose, you can remove outer tie rod nut (3). Take care not to pinch and ruin the grease seal of the tie rod while using Puller, Special Tool C-4150A to remove it from the knuckle. Following this, use the Puller (2), Special Tool C-4150A, to disconnect the outer tie rod (1) from the knuckle (3) and then twist the outer tie rod off the inner tie rod to finish the whole procedure.

OEM 2009 Dodge Viper Tie Rod End

Steering Rod End

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Tie Rod End found

View related parts
2009 Dodge Viper Outer Tie Rod, Rear Part Number: 5290168AC
$45.07 MSRP: $54.00
You Save: $8.93 (17%)
ADD TO CART
Product Specifications
- Other Name: Tie Rod - Outer; Steering Tie Rod End, Front Outer, Outer, Rear Outer; Drag Link Repair Kit
- Position: Rear Outer
- Replaces: 5290168AB, 5290168AA
- Item Weight: 1.80 Pounds
- Item Dimensions: 5.9 x 1.9 x 4.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5290168AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2009 Dodge Viper Submodels:
- SRT-10, SRT-10 ACR | 10 Cyl 8.3 L GAS, 10 Cyl 8.4 L GAS, 8.4L V10

2009 Dodge Viper Tie Rod End Parts and Q&A

Q: How to Service and Repair a Tie Rod End on 2009 Dodge Viper?
A: Before servicing or repairing the tie rod end, raise and support the vehicle. After that, take off the front wheel and tire assembly. Begin by loosening the jam nut (2) on the inside and once that's loose, you can remove outer tie rod nut (3). Take care not to pinch and ruin the grease seal of the tie rod while using Puller, Special Tool C-4150A to remove it from the knuckle. Following this, use the Puller (2), Special Tool C-4150A, to disconnect the outer tie rod (1) from the knuckle (3) and then twist the outer tie rod off the inner tie rod to finish the whole procedure.