How to Service and Repair a Cruise Control Servo on 2010 Chrysler PT Cruiser?

Disconnect the negative battery cable as the first step in working on the cruise control servo. After that, unfasten the throttle control shield and pull the speed control cable free from the throttle body lever. Then, take off the vacuum line from the speed control servo and undo the 2 nuts that hold it to its studs. Slide the attachment side of the speed control servo out and slide the other end back in, detach the connector from the servo and take out the 2 push clips, getting rid of them. Remove the clip that is holding the cable to the servo.

OEM 2010 Chrysler PT Cruiser Cruise Control Servo

Cruise Control Servo Speed

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Cruise Control Servo found

View related parts
2010 Chrysler PT Cruiser Cruise Servo Part Number: 4669977
Product Specifications
- Other Name: Servo - Speed Control; Cruise Control Module; Cruise Control Servo; Servo; Servo Speed Control; Servo, Vacuum
- Item Weight: 1.20 Pounds
- Item Dimensions: 5.3 x 4.8 x 4.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4669977
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2010 Chrysler PT Cruiser Submodels:
- Base, Classic, Couture Edition, Dream, Dream Cruiser, GT, LX, Limited, Street Cruiser, Touring | 4 Cyl 2.4 L GAS

2010 Chrysler PT Cruiser Cruise Control Servo Parts and Q&A

Q: How to Service and Repair a Cruise Control Servo on 2010 Chrysler PT Cruiser?
A: Disconnect the negative battery cable as the first step in working on the cruise control servo. After that, unfasten the throttle control shield and pull the speed control cable free from the throttle body lever. Then, take off the vacuum line from the speed control servo and undo the 2 nuts that hold it to its studs. Slide the attachment side of the speed control servo out and slide the other end back in, detach the connector from the servo and take out the 2 push clips, getting rid of them. Remove the clip that is holding the cable to the servo.