OEM Dodge Sprinter 2500 Wiper Blade

Dodge Sprinter 2500 Wiper Blade Parts and Q&A

• Wiper Blade, Front Driver Side
  68055456AA
  Q: How to Safely Service and Repair a Front Wiper Blade on Dodge Sprinter 2500?

  A:

  Unplug the key from the ignition when servicing the front wiper blades to keep the wipers from moving when you don't notice and possibly injuring yourself. Do not open the Hood if the Wiper Arms are tucked against the Windshield, because both could be harmed. When wiping, wait for the wiper arm to sit against the moving blade before wiping the glass to avoid damaging the windshield; resting the wiper arms on the glass without the blades can cause scratches. You will find that the right arm and left blade are not the same length, with the right arm being the longest. Pull up the wiper arm with the weathervane until it moves past the hinge. Grip the blade to the tip of the arm bracket and then insert the upper end of the pivot block over the tab of the bracket. Lift the lower end of the pivot block into the bracket until you hear the latch release tabs lock, showing they are in their proper position. In the end, slowly set the windshield wiper blade on the windshield.
• Blade Assembly Refill
  5133992AA
  Q: How to Remove and Install Wiper Blades on Dodge Sprinter 2500?

  A:

  The Wiper Arms are not the same length on this car; the longer one is installed on the left (driver) side of the windshield. To take the wiper blade off, first turn the wiper switch to On and let the wiper blades reach a convenient place by cycling the Ignition Switch between On and Off. Raise the wiper arm so that the wiper blade comes off the glass and the arm's hinge is higher than the center. Slide the tip of the arm up to depress the release tab and pull the blade away from the end of the arm to remove the pivot block from the hook. With the wiper arm not allowed to spring toward the glass, detach the hook portion from the hinge at the opening in the wiper blade superstructure. Slowly push the wiper arm tip down onto the window. To attach the wiper, raise the arm off the windshield until it's far enough, then match the side of the blade with the loop at the end of the wiper arm. Open the wiper blade sleeve through which the arm assembles into and drive the hook seen at the end of the wiper arm through until it attaches to the pivot block. Lift the wiper blade pivot block/latch up into the hook, making sure the latch release tab reaches its locked position-you should hear a click. After that, carefully position the wiper so that it rests on the glass.