OEM Dodge Sprinter 3500 Engine Oil Cooler

Dodge Sprinter 3500 Engine Oil Cooler Parts and Q&A

• Oil Cooler
  5179360AB
  Q:

  How to Service and Repair an Engine Oil Cooler on Dodge Sprinter 3500?

  A:

  The first thing to do is remove the negative Battery Cable and drain all the coolant from the cooling system. After that, take out the air cleaner assembly, then disconnect the Coolant Reservoir and the hoses. Also, take off the charge air cooler hose between the turbo and cooler and remove the turbo as the next step. Following that step, separate the lower radiator hose where it connects to the Water Pump housing assembly and then remove the water pump housing assembly altogether. In the end, take out the engine oil cooler from your assembly.
• Oil Cooler
  68033097AA
  Q:

  How to Install an Engine Oil Cooler and Its Components on Dodge Sprinter 3500?

  A:

  You should clean the engine mating surfaces before beginning the installation of the oil cooler. Place the oil cooler and gasket, then mount and tighten the bolts up to 10.8 Nm (96 in. lbs.). After that, mount the water pump housing assembly using an updated gasket and hand tighten the fasteners to equal 18 ft. lbs. Install the oil cooler hose for the coolant and the power steering reservoir in that order. Install the heater hoses in the housing, next install the lower radiator hose and then finalize with the charge air hose. Third, place the Coolant Reservoir and the hoses, the turbocharger next and finally the air cleaner assembly. Add the coolant, attach the negative Battery Cable, start the engine, allow it to run until warm, switch it off and look for drips.