How to Remove and Install a MAP Sensor on 2000 Dodge Viper?

A manifold absolute pressure sensor is installed on the driver's side of the engine's intake manifold. Unplug the connector from the sensor first, then remove all the screws that hold it in place. The sensor's vacuum hose goes to a vacuum on the intake manifold plenum and is removed when you pull the sensor and hose off the manifold. For installation, set the sensor and vacuum hose in place over the intake manifold, use the mounting screws to secure everything, tightening them to 3 Nm (23 in. lbs.) and finally attach the electrical connector.

OEM 2000 Dodge Viper MAP Sensor

Manifold Air Pressure Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 MAP Sensor found

View related parts
2000 Dodge Viper M.A.P. Sensor Part Number: 56029405
$181.75 MSRP: $272.00
You Save: $90.25 (34%)
ADD TO CART
Product Specifications
- Other Name: Sensor - Map; Manifold Absolute Pressure Sensor; Manifold Sensor; MAP Sensor; Sensor Map See Note; Sensor Map; Pressure Sensor
- Item Weight: 0.50 Pounds
- Item Dimensions: 2.8 x 2.6 x 1.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56029405
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2000 Dodge Viper Submodels:
- ACR, GT2, GTS, R/T-10 | 10 Cyl 8.0 L GAS

2000 Dodge Viper MAP Sensor Parts and Q&A

Q: How to Remove and Install a MAP Sensor on 2000 Dodge Viper?
A: A manifold absolute pressure sensor is installed on the driver's side of the engine's intake manifold. Unplug the connector from the sensor first, then remove all the screws that hold it in place. The sensor's vacuum hose goes to a vacuum on the intake manifold plenum and is removed when you pull the sensor and hose off the manifold. For installation, set the sensor and vacuum hose in place over the intake manifold, use the mounting screws to secure everything, tightening them to 3 Nm (23 in. lbs.) and finally attach the electrical connector.