How to Service a Brake Master Cylinder on 2002 Dodge Dakota?

Start by disconnecting the brake line, unplugging the fluid level alarm and getting rid of the mounting nuts so the brake master cylinder comes off. Bleeding the brake master cylinder is essential before you install it. After that, fit the new brake master cylinder onto the booster at its studs, fasten it against each stud using nuts tightened to 18 Nm (160 inch lbs.) and then link up the brake lines, sealing them with nuts that have been tightened to 19 Nm (170 inch lbs.). Attach the low fluid level switch connection and bleed the brake lines on the base booster after that.

OEM 2002 Dodge Dakota Brake Master Cylinder

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Brake Master Cylinder found

View related parts
2002 Dodge Dakota Master Cylinder Part Number: 5093049AA
Product Specifications
- Other Name: Master Cylinder - Brake; Brake Master Cylinder; Master Cylinder Brake
- Item Weight: 2.70 Pounds
- Item Dimensions: 10.9 x 7.9 x 5.4 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5093049AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2002 Dodge Dakota Submodels:
- Base, R/T, SLT, SLT Plus, SXT, Sport, Sport Plus | 4 Cyl 2.5 L GAS, 6 Cyl 3.7 L GAS, 6 Cyl 3.9 L GAS, 8 Cyl 4.7 L GAS, 8 Cyl 5.2 L GAS, 8 Cyl 5.9 L GAS

2002 Dodge Dakota Brake Master Cylinder Parts and Q&A

Q: How to Service a Brake Master Cylinder on 2002 Dodge Dakota?
A: Start by disconnecting the brake line, unplugging the fluid level alarm and getting rid of the mounting nuts so the brake master cylinder comes off. Bleeding the brake master cylinder is essential before you install it. After that, fit the new brake master cylinder onto the booster at its studs, fasten it against each stud using nuts tightened to 18 Nm (160 inch lbs.) and then link up the brake lines, sealing them with nuts that have been tightened to 19 Nm (170 inch lbs.). Attach the low fluid level switch connection and bleed the brake lines on the base booster after that.