How to Service and Repair the Neutral Safety Switch on 2004 Dodge Dakota?

To replace the Transmission Position Switch/Sensor, you should first unplug the connector and remove the valve body outside the vehicle. Then, remove the manual shaft seal and manually shaft/TRS retaining screw and slide the TRS off the manual valve shaft. For assembly, set the TRS onto the manual shaft so that its locating pin is positioned inside the manual valve bore slot. First, use 5 Nm (45 inch lbs.) of torque on the TRS/manual shaft retaining screw, then put the manual shaft seal in and finally attach the valve body to the transmission.

OEM 2004 Dodge Dakota Neutral Safety Switch

Transmission Neutral Safety Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Neutral Safety Switch found

View related parts
2004 Dodge Dakota Neutral Safety Switch Part Number: 56045489AC
Product Specifications
- Other Name: Switch - Neutral, Safety, Back Up; Switch Neutral Safety, Back Up
- Replaces: 56045489AB
- Item Weight: 0.60 Pounds
- Item Dimensions: 2.5 x 3.0 x 3.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56045489AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2004 Dodge Dakota Submodels:
- Base, Laramie, R/T, SLT, SLT Plus, ST, SXT, Sport, Sport Plus | 4 Cyl 2.5 L GAS, 6 Cyl 3.7 L GAS, 6 Cyl 3.9 L GAS, 8 Cyl 4.7 L GAS, 8 Cyl 5.9 L GAS

2004 Dodge Dakota Neutral Safety Switch Parts and Q&A

Q: How to Service and Repair the Neutral Safety Switch on 2004 Dodge Dakota?
A: To replace the Transmission Position Switch/Sensor, you should first unplug the connector and remove the valve body outside the vehicle. Then, remove the manual shaft seal and manually shaft/TRS retaining screw and slide the TRS off the manual valve shaft. For assembly, set the TRS onto the manual shaft so that its locating pin is positioned inside the manual valve bore slot. First, use 5 Nm (45 inch lbs.) of torque on the TRS/manual shaft retaining screw, then put the manual shaft seal in and finally attach the valve body to the transmission.