How to Remove and Install a MAP Sensor on 2004 Dodge Dakota?

On the front end of the intake manifold is the Manifold Absolute Pressure (MAP) sensor which is Disconnect the connector to the MAP sensor first and afterward, clean up the area around it. After that, loosen the two screws from the MAP sensor and examine the state of the O-ring as you remove it from the intake manifold. When installing, wash the MAP sensor bracket in the intake manifold and make sure the O-ring does not have any rips or nicks. Set the sensor in the manifold, fasten the screws in place and tighten them to 3 Nm (25 in. lbs.) before connecting the electrical connector again.

OEM 2004 Dodge Dakota MAP Sensor

Manifold Air Pressure Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 MAP Sensor found

View related parts
2004 Dodge Dakota M.A.P. Sensor Part Number: 56041018AD
$97.73 MSRP: $149.00
You Save: $51.27 (35%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor - Map; Manifold Absolute Pressure Sensor; Manifold Sensor; MAP Sensor; Sensor Map; Pressure Sensor
- Replaces: 56041018AC
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.9 x 2.6 x 3.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56041018AD
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2004 Dodge Dakota Submodels:
- Base, Big Horn, Laramie, Lone Star, R/T, SLT, SLT Plus, ST, SXT, Sport, Sport Plus, TRX, TRX4 | 3.7L V6, 4.7L V8, 6 Cyl 3.7 L GAS, 6 Cyl 3.9 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.9 L GAS

2004 Dodge Dakota MAP Sensor Parts and Q&A

Q: How to Remove and Install a MAP Sensor on 2004 Dodge Dakota?
A: On the front end of the intake manifold is the Manifold Absolute Pressure (MAP) sensor which is Disconnect the connector to the MAP sensor first and afterward, clean up the area around it. After that, loosen the two screws from the MAP sensor and examine the state of the O-ring as you remove it from the intake manifold. When installing, wash the MAP sensor bracket in the intake manifold and make sure the O-ring does not have any rips or nicks. Set the sensor in the manifold, fasten the screws in place and tighten them to 3 Nm (25 in. lbs.) before connecting the electrical connector again.