How to Service and Install a MAP Sensor on the Intake Manifold on 2005 Dodge Neon?

The MAP sensor should be taken out of the intake manifold plenum by disconnecting its electrical connector and then removing its screws. Gently push the sensor into the manifold and then screw the mounting bolts to a torque of 45 N-m (40 in lbs) for a plastic manifold, making sure not to damage the O-ring. Until the bolts are loose, don't plug the wiring connector.

OEM 2005 Dodge Neon MAP Sensor

Manifold Air Pressure Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 MAP Sensors found

View related parts
2005 Dodge Neon M.A.P. Sensor Part Number: 5033224AB
$56.38 MSRP: $81.15
You Save: $24.77 (31%)
Product Specifications
- Other Name: Sensor - Map; Manifold Absolute Pressure Sensor; Manifold Sensor; Pressure Sensor; MAP Sensor; Sensor Map
- Replaces: 5033224AA
- Item Weight: 0.50 Pounds
- Item Dimensions: 2.7 x 2.3 x 1.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5033224AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2005 Dodge Neon Submodels:
- SRT-4 | 2.4L L4, 4 Cyl 2.4 L GAS
View related parts
2005 Dodge Neon M.A.P. Sensor Part Number: 4896003AB
Product Specifications
- Other Name: Sensor - Map; Manifold Absolute Pressure Sensor; Manifold Sensor; MAP Sensor; Sensor Map; Pressure Sensor
- Replaces: 4896003AA, 4896002AD
- Item Weight: 0.50 Pounds
- Item Dimensions: 1.8 x 2.6 x 3.7 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4896003AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2005 Dodge Neon Submodels:
- R/T, SE, SXT | 2.0L L4, 4 Cyl 2.0 L GAS

2005 Dodge Neon MAP Sensor Parts and Q&A

Q: How to Service and Install a MAP Sensor on the Intake Manifold on 2005 Dodge Neon?
A: The MAP sensor should be taken out of the intake manifold plenum by disconnecting its electrical connector and then removing its screws. Gently push the sensor into the manifold and then screw the mounting bolts to a torque of 45 N-m (40 in lbs) for a plastic manifold, making sure not to damage the O-ring. Until the bolts are loose, don't plug the wiring connector.