How to Remove and Install the Intake Manifold Temperature Sensor on 2005 Jeep Grand Cherokee?

This sensor which monitors IMT, is located on the left side of the intake manifold plenum. You should first take out the connector from the IMT sensor to remove it. Cleaning any debris from around the sensor base, carefully lift the little plastic release, then twist the sensor counter-clockwise about a quarter turn to remove it. Make sure the sensor's O-ring is in good shape. Be sure to inspect the O-ring and wipe clean the sensor opening in the intake manifold for installation. Set the sensor into the intake manifold and spin it clockwise until it comes over the release pin, then attach the electrical connector.

OEM 2005 Jeep Grand Cherokee Intake Manifold Temperature Sensor

Air Intake Temperature Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Intake Manifold Temperature Sensor found

View related parts
2005 Jeep Grand Cherokee Temperature Sensor Part Number: 56028364AA
$38.57 MSRP: $55.45
You Save: $16.88 (31%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor - Air Temperature; Air Charge Temperature Sensor; Air Temperature Sensor; Ambient Temperature Sensor; Air Intake Temperature Sensor; Duct Air Temperature Sensor.
- Item Weight: 0.40 Pounds
- Item Dimensions: 2.5 x 1.1 x 0.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56028364AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2005 Jeep Grand Cherokee Submodels:
- 65th Anniversary Edition, Laredo, Limited, Overland, Special Edition, Sport | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L GAS

2005 Jeep Grand Cherokee Intake Manifold Temperature Sensor Parts and Q&A

Q: How to Remove and Install the Intake Manifold Temperature Sensor on 2005 Jeep Grand Cherokee?
A: This sensor which monitors IMT, is located on the left side of the intake manifold plenum. You should first take out the connector from the IMT sensor to remove it. Cleaning any debris from around the sensor base, carefully lift the little plastic release, then twist the sensor counter-clockwise about a quarter turn to remove it. Make sure the sensor's O-ring is in good shape. Be sure to inspect the O-ring and wipe clean the sensor opening in the intake manifold for installation. Set the sensor into the intake manifold and spin it clockwise until it comes over the release pin, then attach the electrical connector.