OEM 2006 Chrysler Crossfire Brake Master Cylinder

2006 Chrysler Crossfire Brake Master Cylinder Parts and Q&A

• Q: How to Remove and Install a Brake Master Cylinder on 2006 Chrysler Crossfire?

  A: You first need to separate the brake fluid level sensor harness connector from the reservoir and the master cylinder brake fluid pressure sensor harness connectors to remove the LHD master cylinder. After that, undo the brake lines from the master cylinder and take out the nuts that hold it to the booster studs, trying not to tilt the master brake cylinder as you remove it. When you've pulled the master cylinder, also take off the O-ring. On the bench, bleed and full the master cylinder and then attach the O-ring onto the master cylinder. Secure the master cylinder to the booster by tightening the mounting nuts to 20 Nm (15 ft. lbs). Clip the brake lines onto the master cylinder, make sure the tightening torque is 14 Nm (10 ft. lbs.) and then attach the fluid level sensor harness connector to the tank. You should also finish by pushing fluid all the way to the ends of every brake line and master cylinder chamber or bleed the system.