How to Service a Power Steering Pump on 2006 Jeep Liberty?

Before working on the power steering pump, you should drain out as much fluid as you can. Then, detach the serpentine drive belt and then pull off the power steering high pressure hose and the return pipe at the pump. After that, take out the three bolts that hold the pump to the engine using the holes in the pulley and remove the pump from your car. After mounting it back in the vehicle, seal the pump with the three bolts and tighten them to 47 Nm (35 ft. lbs.). Put the power steering hoses back, place the serpentine belt and then check and refill the fluid as you add it.

OEM 2006 Jeep Liberty Power Steering Pump

Power Steering Pump Unit

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Power Steering Pumps found

View related parts
2006 Jeep Liberty Power Steering Pump Part Number: 52088710AE
Product Specifications
- Other Name: Pump - Power Steering; Pump Power Steering
- Replaces: RL088710EE, RLX88710EE, 52088710AD, 52088710AC, RX088710EE
- Item Weight: 4.80 Pounds
- Item Dimensions: 12.0 x 7.4 x 7.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 52088710AE
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2006 Jeep Liberty Submodels:
- 65th Anniversary Edition, Limited, Renegade, Rocky Mountain Edition, Sport | 6 Cyl 3.7 L GAS
View related parts
2006 Jeep Liberty Power Steering Pump Part Number: 52088712AC
Product Specifications
- Other Name: Pump - Power Steering; Pump Power Steering
- Item Weight: 3.80 Pounds
- Item Dimensions: 7.1 x 5.3 x 5.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 52088712AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2006 Jeep Liberty Submodels:
- Limited, Sport | 4 Cyl 2.8 L DIESEL

2006 Jeep Liberty Power Steering Pump Parts and Q&A

Q: How to Service a Power Steering Pump on 2006 Jeep Liberty?
A: Before working on the power steering pump, you should drain out as much fluid as you can. Then, detach the serpentine drive belt and then pull off the power steering high pressure hose and the return pipe at the pump. After that, take out the three bolts that hold the pump to the engine using the holes in the pulley and remove the pump from your car. After mounting it back in the vehicle, seal the pump with the three bolts and tighten them to 47 Nm (35 ft. lbs.). Put the power steering hoses back, place the serpentine belt and then check and refill the fluid as you add it.