Other Name: Pan - Oil; Engine Oil Pan, Lower; Oil Pan
Position: Lower
Condition: New
Fitment Type: Direct Replacement
SKU: 4666021AC
Warranty: This genuine part is guaranteed by Mopar's
factory warranty.
Fits the following 2007 Jeep Wrangler Submodels:
Rubicon, Sahara, Unlimited Rubicon, Unlimited Sahara, Unlimited X, X | 6 Cyl 3.8 L GAS
2007 Jeep Wrangler Oil Pan Parts and Q&A
Q: How to Remove and Replace an Oil Pan on 2007 Jeep Wrangler?
A: To change the oil pan, clean the sealing spots of old or dirty oil, sealer or dirt, then put a 1/8 inch strip of Mopar. At the where the chain case cover meets the rear seal retainer is the Engine RTV GEN II. After that, place a new pan gasket on the oil pan, install it onto the vehicle and tighten the bolts to 12 Nm (105 in. lbs.). Following that, fit the structural cover and make sure the fasteners are tightened. With the vehicle at a low point, add the oil level indicator and afterwards attach a new oil filter. Afterward, put oil in the crankcase until it reaches the mark and link the negative battery wire to the engine block.