How to Install an Oil Pan on 2008 Jeep Wrangler?

Before installing the oil pan, wipe away all oil, dirt and sealer from the places where the seals fit and then put 1/8 inch of Mopar(R) Engine RTV GEN II around where the chain cover connects to the rear seal retainer. Then, put a new pan gasket on the oil pan, fit the oil pan into its place and tighten the bolts using 12 Nm (105 in. lbs.) of torque. Afterward, set up the structural cover and tighten the bolts. Put the car on the ground, set in the oil level indicator and install the new oil filter. The last step is to fill the crankcase with oil, then attach the negative cable to the battery.

OEM 2008 Jeep Wrangler Oil Pan

Oil Drain Pan

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Oil Pan found

View related parts
2008 Jeep Wrangler Oil Pan Part Number: 4666153AC
$397.32 MSRP: $583.00
You Save: $185.68 (32%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Pan - Oil; Engine Oil Pan; Upper Oil Pan; Lower Oil Pan; Pan Oil
- Item Weight: 10.10 Pounds
- Item Dimensions: 24.5 x 17.1 x 10.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4666153AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2008 Jeep Wrangler Submodels:
- 70th Anniversary, Rubicon, Sahara, Sport, Unlimited 70th Anniversary, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport, Unlimited X, X, X-S | 6 Cyl 3.8 L GAS

2008 Jeep Wrangler Oil Pan Parts and Q&A

Q: How to Install an Oil Pan on 2008 Jeep Wrangler?
A: Before installing the oil pan, wipe away all oil, dirt and sealer from the places where the seals fit and then put 1/8 inch of Mopar(R) Engine RTV GEN II around where the chain cover connects to the rear seal retainer. Then, put a new pan gasket on the oil pan, fit the oil pan into its place and tighten the bolts using 12 Nm (105 in. lbs.) of torque. Afterward, set up the structural cover and tighten the bolts. Put the car on the ground, set in the oil level indicator and install the new oil filter. The last step is to fill the crankcase with oil, then attach the negative cable to the battery.