OEM 2008 Chrysler PT Cruiser Washer Pump

2008 Chrysler PT Cruiser Washer Pump Parts and Q&A

• Q: How is the Washer Pump Installed on 2008 Chrysler PT Cruiser?

  A: Each time you take out or put in the windshield washer pump, use a brand new grommet where the pump attaches to avoid leaking. Put the grommet in the reservoir first and next insert the pump inside it. Wrap the pump assembly in a plastic strap and place the other end securely in the reservoir. Drop the reservoir into the cowl and link the washer hoses, with the white striped hose attaching to the white side of the pump and the black hose attaching to the black side. After that, connect the pump wire and attach the three reservoir screws, ensuring that the torque for all is 8 Nm (70 in. lbs.) Neatly fit the cowl cover in place and fasten it with four push retainers, after that, install the rear engine compartment seal at the cowl. Turn on the wiper system and bring the front wiper arms up until the driver's and passenger's blade tips are at the windshield park markers. Put the arm at its center balance point on the pivot and after that, tighten the wiper arm nut to reach 21 Nm torque. Make sure the wiper arm nut cap is installed, then reattach the battery negative cable, shut the hood and check the vehicle and its systems.