OEM 2009 Chrysler PT Cruiser Washer Pump

2009 Chrysler PT Cruiser Washer Pump Parts and Q&A

• Q: How to Install a Washer Pump on 2009 Chrysler PT Cruiser?

  A: It is important to fit a new grommet under the washer pump each time you remove or connect the pump from the reservoir. The first step is to set the new grommet into the reservoir and then slide the pump into the grommet. Latch the pump assembly by wrapping it with a plastic strap and snapping it into the reservoir. Affix the reservoir in the appropriate spot above the cowl and link the match the white-striped washer hose with the white side of the pump and the black hose with the black side. Then, fasten the wires at the pump, put in three reserve retaining screws and tighten them with a torque of 8 Nm (70 in. lbs.). Set the cowl cover in the right spot and fasten it with four push retainers before installing the rear engine compartment seal in place on top of the cowl. Make sure the system is set in PARK and that the driver's wiper blade tip and the passenger's blade middle are level with the windshield park mark before fitting the front wiper arms. Hold the arm in its over/centered position on the pivot, add the wiper arm retaining nut and tighten it to 190 in. lbs. (21 Nm). Place the wiper arm nut cap, link up the battery negative cable, close the hood and test the new system.