How to Service a Yaw Sensor on 2008 Dodge Caliber?

The first step in servicing the Yaw Rate Sensor is to separate and isolate the battery negative cable from the post. Afterward, take off the shifter housing center console. Separate the wiring harness connector from the dynamics sensor when you're done. After that, disconnect the nuts holding the dynamics sensor up from the floor pan tunnel. After that, take out the dynamics sensor.

OEM 2008 Dodge Caliber Yaw Sensor

Yaw Rate Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Yaw Sensor found

View related parts
2008 Dodge Caliber Yaw Rate Sensor Part Number: 5033322AC
Product Specifications
- Other Name: Module - Electronic Stability; Control Module; Stab Control Module; Sensor Dynamics Lateral Acceleration And Yaw Rate
- Item Weight: 4.10 Pounds
- Item Dimensions: 10.5 x 6.3 x 6.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5033322AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2008 Dodge Caliber Submodels:
- R/T, SE, SRT-4, SXT | 4 Cyl 1.8 L GAS, 4 Cyl 2.0 L GAS, 4 Cyl 2.4 L GAS

2008 Dodge Caliber Yaw Sensor Parts and Q&A

Q: How to Service a Yaw Sensor on 2008 Dodge Caliber?
A: The first step in servicing the Yaw Rate Sensor is to separate and isolate the battery negative cable from the post. Afterward, take off the shifter housing center console. Separate the wiring harness connector from the dynamics sensor when you're done. After that, disconnect the nuts holding the dynamics sensor up from the floor pan tunnel. After that, take out the dynamics sensor.