How to Service and Repair the Rear Blend Door Actuator on 2008 Dodge Durango?

Before servicing or repairing the Air Door Actuator/Motor for rear controls, remove and disconnect the negative battery cable. After that, take out the trim that surrounds the rear passenger door. Remove the rear HVAC wire harness from the actuator that is wired with the rear HVAC on the mode door. Once done, pull out the screws on the rear mode door actuator attached to the rear HVAC housing and remove the actuator from inside the housing.

OEM 2008 Dodge Durango Blend Door Actuator

Air Blend Door Actuator

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Blend Door Actuator found

View related parts
2008 Dodge Durango Door Actuator Part Number: 4885206AB
$137.09 MSRP: $202.00
You Save: $64.91 (33%)
Product Specifications
- Other Name: Actuator - A/C And Heater; HVAC Air Adjustment Control Motor; HVAC Heater Blend Door Actuator; HVAC Blend Door Actuator; Actuator; Servo; A/C and Heater Actuator with Bracket, Lever, and Recirculation Door.
- Item Weight: 0.70 Pounds
- Item Dimensions: 1.9 x 3.6 x 4.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4885206AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2008 Dodge Durango Submodels:
- Adventurer, Base, Limited, Limited Hybrid, R/T, SE, SLT, SLT Plus, ST, SXT, Sport | 6 Cyl 3.7 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.7 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 5.7 L GAS, 8 Cyl 5.9 L GAS

2008 Dodge Durango Blend Door Actuator Parts and Q&A

Q: How to Service and Repair the Rear Blend Door Actuator on 2008 Dodge Durango?
A: Before servicing or repairing the Air Door Actuator/Motor for rear controls, remove and disconnect the negative battery cable. After that, take out the trim that surrounds the rear passenger door. Remove the rear HVAC wire harness from the actuator that is wired with the rear HVAC on the mode door. Once done, pull out the screws on the rear mode door actuator attached to the rear HVAC housing and remove the actuator from inside the housing.