How to Service and Repair a Blend Door Actuator on 2009 Dodge Nitro?

First, the negative battery cable should be disconnected to stop the air bag system, then you must wait for two minutes so that any accidental deployment is prevented. Begin with getting rid of the silencer if you have one below your left side dash panel. After that, take out the wire harness plug connected to the blend door actuator on the driver side of the air distribution housing. Last, remove the pair of screws holding the actuator to the mounting bracket and pull the actuator out.

OEM 2009 Dodge Nitro Blend Door Actuator

Air Blend Door Actuator

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Blend Door Actuator found

View related parts
2009 Dodge Nitro Actuator Part Number: 68004016AA
$122.36 MSRP: $182.00
You Save: $59.64 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Actuator - A/C And Heater; HVAC Air Inlet Door Actuator; HVAC Blend Door Actuator; HVAC Heater Blend Door Actuator; Actuator A/C And Heater
- Item Weight: 0.70 Pounds
- Item Dimensions: 1.2 x 2.4 x 3.6 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 68004016AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2009 Dodge Nitro Submodels:
- Detonator, Heat, R/T, SE, SLT, SXT, Shock | 6 Cyl 3.7 L GAS, 6 Cyl 4.0 L GAS

2009 Dodge Nitro Blend Door Actuator Parts and Q&A

Q: How to Service and Repair a Blend Door Actuator on 2009 Dodge Nitro?
A: First, the negative battery cable should be disconnected to stop the air bag system, then you must wait for two minutes so that any accidental deployment is prevented. Begin with getting rid of the silencer if you have one below your left side dash panel. After that, take out the wire harness plug connected to the blend door actuator on the driver side of the air distribution housing. Last, remove the pair of screws holding the actuator to the mounting bracket and pull the actuator out.