How to install a Brake Master Cylinder on 2009 Dodge Nitro?

Always bleed the new master cylinder before putting it in place. Clean the surface on the brake booster where the cylinder attaches. Put the O-ring on the master cylinder at the place where it meets the booster. Attach the master cylinder to the brake booster studs and secure it with the mounting nuts, turning them to 17 Nm (151 in. lbs.). Attach the brake lines to the master cylinder and tighten them to 19 Nm (168 in. lbs.) and then put the fluid level electrical connector into the reservoir. When everything's ready, fill and bleed the main part of the brake assembly.

OEM 2009 Dodge Nitro Brake Master Cylinder

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Brake Master Cylinder found

View related parts
2009 Dodge Nitro Master Cylinder Part Number: 68004467AD
Product Specifications
- Other Name: Cylinder - Brake; Brake Master Cylinder; Master Cylinder Assembly
- Replaces: 68004467AC, 68004467AA, 68004467AB
- Item Weight: 2.50 Pounds
- Item Dimensions: 6.8 x 9.2 x 9.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 68004467AD
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2009 Dodge Nitro Submodels:
- Detonator, Heat, R/T, SE, Shock, SLT, SXT | 3.7L V6, 4.0L V6, 6 Cyl 3.7 L GAS, 6 Cyl 4.0 L GAS

2009 Dodge Nitro Brake Master Cylinder Parts and Q&A

Q: How to install a Brake Master Cylinder on 2009 Dodge Nitro?
A: Always bleed the new master cylinder before putting it in place. Clean the surface on the brake booster where the cylinder attaches. Put the O-ring on the master cylinder at the place where it meets the booster. Attach the master cylinder to the brake booster studs and secure it with the mounting nuts, turning them to 17 Nm (151 in. lbs.). Attach the brake lines to the master cylinder and tighten them to 19 Nm (168 in. lbs.) and then put the fluid level electrical connector into the reservoir. When everything's ready, fill and bleed the main part of the brake assembly.